Replacing the processor | Fujitsu RX200 S5 instruction

Replacing the processor

Processors

5.2Replacing the processor

VCAUTION!

Only processors of the same type may be used on the system board.

ÊOpen the server as described in chapter “Preparation” on page 19.

ÊLift the air cowl upwards to remove it as described in section “Removing the air cowl” on page 22.

Figure 9: Removing the heat sink

ÊLoosen the four screws of the heat sink in a crossover pattern.

ÊLoosen the heat sink carefully by turning it back and forth. Then lift it up and off.

ÊRemove the residual thermal paste from the underside of the heat sink.

ÊClean the underside of the heat sink using a lint-free cloth.

26

Options Guide

RX200 S5

Image 26

Fujitsu RX200 S5 manual Replacing the processor

Contents

Primergy RX200 S5 Server Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISO Contents Contents Documentation overview PrefaceConcept and target groups Documentation overview Preface Further sources of information Expansions and conversions Expansions and conversions Preface TPM Notational conventions Page Procedure Page Safety instructions Installation and operation Before starting up Options Guide Batteries Never remove parts of the CD/DVD drive casing Working with CDs/DVDs and CD/DVD drivesLaser information Modules with electrostatic-sensitive components ESD label Preparation Pulling out/removing the server Opening the server Preparation Removing the housing coverOpening the server Removing the fan cover Opening the server Removing the air cowl Removing the air cowl Preparation Installing a second processor Processors Installing a second processor Inserting the processor Installing the heat sink Processors Replacing the processor Replacing the processor Replacing the processor Replacing the processor Replacing the heat sink Page Main memory Equipping rules Independent Channel ModeMirrored Channel Mode Equipping rules Main memory Performance Channel ModeSpare Channel Mode Extending/replacing the main memory Removing installed memory modulesExtending/replacing the main memory Inserting memory modules Inserting a memory modulePage Accessible drive Installing a Sata DVD drive Installing a Sata DVD drive Installing a Sata DVD drive Page HDD modules Removing an existing DVD drive or dummy module Removing the DVD drive or dummy module Removing the DVD drive cage Demounting the DVD drive cage Installing the backplane 8x HDD Removing the existing backplane 6x HDD Installing the drive cage for 8x HDD Installing the HDD drive cage HDD #6 HDD #7 Inserting the HDD modules Installing an expansion card in riser cards Expansion cards and iBBU Removing the riser card holders Installing an expansion card in riser cardsInstalling an expansion card Riser card holder #2 with riser card Reinstalling the riser card holders Riser card holder equipped with a controller Installing the riser card holder Installing a modular RAID controllerInstalling a RAID controller Expansion cards and iBBU Installing an iBBU Installing an iBBU Installing an iBBU Installing the iBBU IBBU Routing the cable Connecting the cable to the modular RAID 5 controller USB solid state disk uSSD Position of the uSSD on the system boardPage Installing the TPM module Trusted Platform Module TPMPage Completion Fitting the air cowl Dimm CPU #1 Fitting the air cowl Fan #3/#4 Fan #1/#2 Completion Fan #11/#12 Closing the server Fit the fan cover see Removing the fan cover onPage Description From CablingCabling overview Cable diagrams Cable diagrams Cabling Cabling for up to 6 HDD modules Cabling for up to 8 HDD modules Index