Installation
Telephone base installation
It is recommended to install the telephone base away from any electronic equipment and appliances such as personal computers, computer routers, television sets, microwave ovens, and refrigerators. Avoid excessive heat, cold, dust or moisture. When a location is selected, install the telephone base and the charger as shown below.
•Plug the connector into the power jack at the bottom of the telephone base and chargers. Route cords through slots and plug the power adapter into an electrical outlet not controlled by a wall switch.
•Plug one end of the telephone line cord into the telephone line jack at the bottom of the telephone base. Route the telephone line cord through slot, then plug the other end of the cord into the modular wall telephone outlet.
Your telephone base comes with the bracket installed for desktop use. If you prefer to mount your telephone on the wall, plug in the telephone line cord and the power adapter to the telephone base as instructed above before changing it to a wall mount position (see page 7 for bracket installation).
• Use only the AC |
power adapter |
supplied with this |
telephone. |
• This power unit |
is intended to be |
correctly oriented |
in a vertical |
or floor mount |
position. The |
prongs are not |
designed to hold |
the plug in place |
if it is plugged |
Installation
Basic operation
Plug the telephone line cord into a telephone jack.
Plug power adapter into an electrical outlet not controlled by a wall switch.
into a ceiling or |
an |
table/cabinet |
outlet. |
www.vtechphones.com
