Carefully unpack the vibration plate and support from their cartons. See DRW 1 and DRW 2. Once everything has been unpacked and all parts are accounted for (page 11), start the assembly process.
Product Assembly
1.Move the Support (2) close to the main vibration plate body (1) and connect the harness (W1) from the base frame to the harness (W2) from the Support. Make sure the connectors are fully connected as vibration could make them come apart over time.
2.Carefully tuck the harness into the support and install the support (2) onto the base frame using the 5 Allen Head Bolts (3), the 5 Spring Washers (4) and the 5 Flat Washers (5). (Do not smash the wire harness between the support and the vibration plate during this step.) Loosely install all 5 bolts and then tighten all at once.
3.Install the base frame Switch Cover (13) onto the base and attach with 4 Phillips Head Screws (15).
4.Install the Left (6) and Right (7) Handlebars onto the Support (2) using Phillips Head Screws (8).
5. Install the console mount (9) onto the Handlebars (6 and 7) and install the two Allen Head Bolts (10).
6. Securely connect wire harness (W3) coming from the Support (2) to the wire harness (W4) coming from the console (11).
7. Install the console (11) onto the Console Mount (9) and install the 4 Phillips Head Screws (12). Install all 4 screws before tightening.
8. Install the Power Cord 17 and the Console Safety Key.
9. Set the unit on a firm surface. Plush or highly padded carpet may cause excess vibration and noise. Level the unit using the Leveling Feet (16) and the unit is ready to be used.
12
