Lightolier 1100F Series Existing Construction, CUT Opening FIG. a and FIG H, Wire-In Fig. B

INSTRUCTION SHEET NO.

IS:1100F

D0605 PAGE 2 OF 2

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.

This fixture is intended for installation in accordance with the National Electrical Code and local or Federal code specifications. To assure full compliance with codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

EXISTING CONSTRUCTION

Fig. A	Fig. B	Fig. C	Fig. D	Fig. E	Fig. F
1. Cut-Opening	2. Wire-in	3. Put Through	4. Anchor	5. Snap-on	6. Push-up

1.CUT OPENING (FIG. A AND FIG H)

a.Remove ADJUSTABLE MOUNTING BARS.

b.Use MOUNTING FRAME opening as template.

c.Break off BRIDGE on MOUNTING FRAME as shown in Fig. H by breaking WEBS on SLOTS with cutting plier.

2.WIRE-IN (FIG. B)

For cable, use built in Cable Clamp in J-BOX. Connect white fixture lead to neutral (white) supply lead. Black fixture leads to hot (black) supply lead. Bare copper and/or green insulated wire(s) must all be connected to supply ground. Use wire nuts (local hardware items).

Place all electrical connections in the J-BOX. Attach J-BOX COVER onto J-BOX.

3.PUT THROUGH (FIG. C AND FIG. J)

Detach BALLAST ASSEMBLY from J-BOX and pass MOUNTING FRAME into ceiling as shown in Fig. C. Reattach BALLAST ASSEMBLY.

4.ANCHOR (FIG. D AND FIG. I)

Using STAPLE (order separately Cat. #1985S), slide long end under- neath raised embossing and short leg into ceiling (Fig. I).

	MOUNTING FRAME
	BRIDGE
Fig. H	SLOT

ROTO CLIP

MOUNTING FRAME

STAPLE

5.	SNAP-ON (FIG. E)	See separate instruction sheet
6.	PUSH-UP (FIG. F)	for your choice of reflector trim.

Fig. I

CEILING MATERIAL

BALLAST REPLACEMENT (FIG. J)

NOTE: Ballast replacement must be provided by a “qualified electrician”.

1.TURN OFF POWER.

2.Remove reflector trim from FRAME-IN KIT.

3.Remove J-BOX COVER nearest ceiling opening by lifting SPRING.

4.Disconnect all input wiring to ballast.

5.Remove BALLAST ASSEMBLY from J-BOX by pulling SPRING upward (Fig. J).

6.Remove BALLAST ASSEMBLY through ceiling opening.

7.Release all wires from BALLAST WIRE CONNECTORS by inserting small blade tool, with insulated handle, into WIRE RELEASE SLOTS. (Fig K).

NOTE: Replacement ballast kits generally are supplied with this special wire release tool.

8.Remove (2) NUTS which hold BALLAST to J-BOX COVER.

9.Replace old BALLAST with new BALLAST and attach with NUTS to J-BOX COVER.

10.Reassemble new BALLAST ASSEMBLY to J-BOX by snapping onto J-BOX spring (Fig. J).

11.Rewire fixture. See WIRING DIAGRAM on BALLAST LABEL.

FRAME	J-BOX SPRING
J-BOX	J-BOX COVER

Fig. J	J-BOX COVER
	REMOVE	INSERT

WIRE RELEASE BLADE

(BY OTHERS)

WIRE RELEASE

SLOTS

BALLAST WIRE

CONNECTORS

®LIGHTOLIER a GENLYTE company. 631 Airport Road, Fall River, MA 02720