READ AND UNDERSTAND THESE INSTRUCTIONS | INSTRUCTION SHEET NO. | |||
BEFORE INSTALLING LUMINAIRE. |
| IS:1101FEM | ||
installation. To prevent electric shock, turn off electricity at main power supply before proceeding. |
| |||
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations. |
|
|
|
|
To assure full compliance with local codes and regulations, check with your local electrical inspector before |
|
|
|
|
Retain these instructions for maintenance reference. |
|
|
|
|
| D1007 |
| Page 1 of 4 |
INSTALLATION PROCEDURE FOR:
Lytecaster® 1001FEM, 1101FEM and 1101FEL Series
CAUTION: (RISK OF FIRE) THIS IS A
DO NOT INSTALL INSULATION ABOVE OR WITHIN 3 INCHES (76mm) OF ANY PART OF LUMINAIRE.
CAUTION: USE ONLY WITH REFLECTOR TRIMS PROVIDED BY LIGHTOLIER. USE OF OTHER MANUFACTURER’S TRIMS
MAY VOID THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.
CAUTION: BEFORE INSTALLING
REFLECTOR TO DETERMINE LAMP WATTAGE AND TYPE APPLICABLE FOR YOUR INSTALLATION.
INSTALLATION INSTRUCTIONS FOR GRID CEILING APPLICATIONS
1PREPARATION: Cut appropriately sized hole in Ceiling Tile (by others) at the position desired and place Ceiling Tile in Grid (by others) (Figure A). Loosen Wing Nuts on Frame Clamps enough to allow free movement of Mounting Bars (Figure B).
*Lightolier offers a hole cutter
APERTURE HOLE SIZE
1001FEM SERIES | |
|
|
1101FEM SERIES | |
|
|
1101FEL SERIES | |
|
|
2POSITION LUMINAIRE FRAME: Place Luminaire Frame on top of Ceiling Tile and center the frame aperture on the Ceiling Tile hole cut in Step 1 so that the aperture wall extends into the Ceiling Tile. Orient the Luminaire Frame to align with the grid (Figure C). Grasp the
NOTE: When the Luminaire Frame is to be used with Wall Wash Trims make sure to orient the Luminaire Frame side indicated by a label on the frame towards the wall to be illuminated.
3CLAMP TO GRID and LOCK LUMINAIRE FRAME: Making certain that the Luminaire Frame is still centered on the Ceiling Tile, tighten the
Figure A | Figure C | Figure E |
| ||
|
|
Figure B | Figure D | Figure F |
*BALLAST REPLACEMENT: Ballast replacement must be performed by a “qualified electrician”. TURN OFF POWER. Remove reflector trim from luminaire. Remove
*REFLECTOR TRIM INSTALLATION: See separate Trim Instruction Sheet for installation procedure.