Lightolier IS 1101FEM, 1001FEM, 1101FEM and 1101FEL Series Frame-InKits, with Emergency Backup

INSTALLATION PROCEDURE FOR:	INSTRUCTION SHEET NO.
1001FEM, 1101FEM and 1101FEL Series Frame-In Kits
		IS:1101FEM
with Emergency Backup
IMPORTANT SAFEGUARDS – READ AND FOLLOW ALL SAFETY		D1007	Page 3 of 4

INSTALLATION INSTRUCTIONS FOR STEEL CONSTRUCTION APPLICATIONS

1PREPARATION: Remove Wing Nuts on T-Bar Clips and reverse clips to inside of Luminaire Frame. Loosen Wing Nuts on Frame Clamps enough to allow free movement of Mounting Bars. Using standard ½” EMT tubing, cut pieces to required length such that it spans across Hat Channel. Position EMT across Frame Mounting Bars and loosely secure to End Brackets with T-Bar Clips. (Figures A, B, & C)

NOTE: The Mounting Bars may be readily adjusted to fit desired openings between 13” (330mm) minimum and 24” (610mm) maximum.

2POSITION AND INSTALL LUMINAIRE FRAME: Position Luminaire Frame at approximate location with EMT resting on Hat Channel. Secure EMT to Hat Channel. Adjust frame to final location by sliding along EMT & Mounting Bars. Lock the Frame in place by tightening the Wing Nuts on the Frame Clamps and T-Bar Clips.

NOTE: When the Luminaire Frame is to be used with Wall Wash Trims make sure to orient the Luminaire Frame side indicated by a label on the frame towards the wall to be illuminated.

Figure A Figure B Figure C

A COMPANY

631 Airport Road, Fall River, MA 02720