READAND UNDERSTANDTHESEINSTRUCTIONSBEFOREINSTALLINGFIXILfRE
tisfixiure is intended for installation in accordancewiththeNefionalElectricalCodeandlocalregulations. Jassurefull complianm with local codes and regulations, check with your Iocd electrical inapecfor before stallation. To prevent elestrfcal shock, turn oft elecfriufy at fuse box before proceeding.
Retain these inatructiona for maintenance reference.
●
INSTRUCTION SHEET NO.
IS:40714
1292 Page1 of 2
INSTRUCTIONS FOR INSTALLATION OF TRADITIONAL STYLE RADIANCE PENDANTS
‘[XTUREASSEMBLYAND INSTALLATION:
1.CarefullyremoveCENTERSTEMASSEMBLYfrompackaging.
2.UnscrewKNURLEDRING from CANOPY LOOP and allow KNURLEO RING and CANOPY to slide down CHAIN to expose CROSSBAR.
3.Mount CROSSBAR and CENTER STEM ASSEMBLY/CHAIN to OUTLET BOX using OUTLET BOX SCREWS (provided with outlet box).
4, Make electrica ccfnnections black ftiure lead or fixture lead without tracer marks to (hot) black supply lea~ white fixhrra lead or fixture lead with trecer mark to (neutral) white supply lead. Uninsulated wire is a ground and must be attached to GREEN GROUNO SCREW enclosed in CUPPEO WASHER and tightened in place to ctossbar, then sunnected to grounding terminal or ground lead inside OUTLET BOX. Use WIRENUTS (local hardware item).
CAUTION Push supply wires and wirenut connections back into OUTLkT BOX.
5.Adjust NIPPLE into CROSSBAR to proper CANOPY depth and secure NIPPLE in place by tightening LOCKNUT against CROSSBAR. B, Slide CANOPY up CHAIN and secare against ceiling by thraadng KNURLED RING onto CANOPY LOOP.
7.Loosen and remove three BATTERY NUTS and STAR WASHERS from MOUNTING STUDS on LOWER FIXFURE ASSEMBLY.
8.Raise LOWER FIXTURE ASSEMBLY to MOUNTING PLATE on CENTER STEM ASSEMBLY and make electricalconnections Snap together BLACK
9,
%
FIG. 1