Precautions:
•Always use locking mechanism and
•Sockets not used must be fitted with blind plugs to ensure IP Degree
•When using the modular plug with open end, is it up to the customer to maintain the IP degree.
•If the MJB – Gateway is used as open loop, there is a risk of not sending an alarm, when no mains are connected. The MJB – Gateway will only send an alarm if mains is missing, when using a Closed Loop (see functionality description.)
•When the Gateway is used on a system with battery, the gateway functionality will follow the power down mode of the control box, see table
CB Power mode | Gateway | |
|
| |
On mains | Function ok | |
|
| |
Power down | No function | |
On battery |
| |
Function ok | ||
“Wake Up” | ||
|
|
•The MJB – Gateway is not to be used as safety, it is only to be used as a guided system.
•It is important to test the specified alarms is working in the correct way, before sending the system to the end user.
•Do not use 2 MJB variants with same device ID on the OpenBus™. This will cause conflicts and the SDT is not able to identify the different products attached.
•Before the final functional test in the production, it is important that the system is
•We recommend the end user to make a regular test procedure in order to prevent failures and hazardous situations on the system, e.g. defective OOB sensor, squeezed cables. The MJB is not able to detect defective 3rd. party products.
•LINAK only takes responsibility for LINAK products, not 3rd. party products. Please pay attention to the “Patient Environment” Clause 3.79 -
It is important to inform the customer about this.
•There can be a risk of conflict with other OpenBus™ accessories, such as HB, ACP, etc. It is therefore recommended to make a system/bit overview.
13
