Lincoln Electric IM10056 manual Left Display Selection, WFS KNOb Range

b-6	OPERATION	b-6
LEFT DISPLAY SELECTION

The left display can show either amperage or actual WFS during welding. Note that actual WFS is not the same as preset WFS. For example, the preset WFS may be set to 400 ipm, but the arc voltage is only 15V. The actual WFS will be approximately 280 ipm because there is not enough arc voltage to run at 400 ipm.

To change the left display reading:

Rotate the WFS knob to the left to display amperage (current).

Rotate the WFS knob to the right to display actual

WFS.

Then rotate the knob to the 12 o’clock position.

Press the set-up button.

d I SP	c u r r
O O A	V

d I SP

O O A

FEEd

V

LN-25 PIPE

LN-25 PIPE

O O WFS

O O WFS

WFS KNOb RANGE

For wire feeders equipped with standard torque gear- ing, the WFS range can be changed to provide better knob sensitivity at low wire feed speeds. This is often useful when welding with Innershield™ wires.

To change the WFS knob range:

Rotate the WFS knob to the left for the low wire feed speed range of 40 – 405 ipm

Rotate the WFS knob to the right for the high wire feed speed range of 40 – 715 ipm.

Then rotate the knob to the 12 o’clock position.

SPd I o

O O A	V
LN-25 PIPE

SPdH I

O O A	V
LN-25 PIPE

O O WFS

O O WFS

Press the set-up button.

LN™-25 PIPE