UNDERCARRIAGES (K817P, K841)
For easy moving of the machine, optional undercar- riages are available with polyolefin wheels (K817P) or a platform undercarriage (K841) with mountings for two gas cylinders at rear of welder.
Install per instructions provided with undercarriage.
Installation of Equipment Required for Recommended Processes
WIRE FEEDER CONTROL CABLE CONNECTIONS
For control cable with
Connect control cable to
Acover (Lincoln Electric Part Number
For control cable with terminal strip connectors:
The control cable from the wire feeding equipment is connected to the terminal strips behind the control panel. A strain relief box connector is provided for access into the terminal strip section. A chassis ground screw is also provided below the terminal strip
marked with the symbol 
for connecting the auto- matic equipment grounding wire. See the appropriate connection diagram for the exact instructions for the wire feeder being used. Refer to “115VAC and 42VAC Auxiliary Power and Control Connections” section for access to terminal strips.
CONNECTION OF CV 500-I TO LN-22 OR LN-25
a)Turn off all power.
b)Connect a jumper from “2 to 4” on terminal strip TS2 or jumper pins “C to D” in
c)Connect the electrode cable to the output terminal of polarity required by electrode. Connect the work lead to the other terminal.
d)Place the OUTPUT CONTROL Switch at “LOCAL” position unless a Remote Control is connected to the CV
NOTE: The output terminals are energized at all times.
– 18 –
