INSTALLATION | ||
|
|
|
TRAILERS (See ACCESSORIES SECTION)
If the user adapts a
1.Design capacity of trailer vs. weight of Lincoln equipment and likely additional attachments.
2.Proper support of, and attachment to, the base of the welding equipment so there will be no undue stress to the framework.
3.Proper placement of the equipment on the trailer to ensure stability side to side and front to back when being moved and when standing by itself while being operated or serviced.
4.Typical conditions of use, i.e., travel speed; rough- ness of surface on which the trailer will be operat- ed; environmental conditions; likely maintenance.
5.Conformance with federal, state, and local laws. (1)
(1)Consult applicable federal, state, and local laws regarding specific requirements for use on pub- lic highways.
VEHICLE MOUNTING
WARNING
Improperly mounted concentrated loads may
POLARITY CONTROL AND CABLE SIZES
With the engine off, route the electrode and work cables through the strain relief bracket on the base and connect to the studs located below the fuel tank mounting rail. (see size recommendations below). For Positive polarity, connect the electrode cable to the terminal marked “Positive”. For Negative polarity, connect the electrode cable to the “Negative” stud. These connections should be checked periodically and tightened if necessary.
When welding at a considerable distance from the welder, be sure you use ample size welding cables.
RECOMMENDED COPPER CABLE SIZES
Cable Sizes for Combined
Length of Electrode Plus
Work Cable
Amps | Duty Cycle | Up to 200 ft | ||
|
|
|
|
|
200 | 60% | 1 | 1/0 |
|
|
|
|
|
|
PRE-OPERATION SERVICE
CAUTION
READ the engine operating and maintenance instructions supplied with this machine.
WARNING
cause unstable vehicle handling and tires or other components to fail.
• Only transport this Equipment on serviceable |
vehicles which are rated and designed for such |
loads. |
• Distribute, balance and secure loads so vehicle |
is stable under conditions of use. |
• Do not exceed maximum rated loads for compo- |
nents such as suspension, axles and tires. |
• Mount equipment base to metal bed or frame of |
vehicle. |
DIESEL FUEL
can
cause fire
•Stop engine while fueling.
•Do not smoke when fueling.
•Keep sparks and flame away from tank.
•Do not leave unattended while fueling.
•Wipe up spilled fuel and allow fumes to clear before starting engine.
•Do not overfill tank, fuel expan- sion may cause overflow.
• Follow vehicle manufacture’s instructions. |
DIESEL FUEL ONLY
PIPELINER 200D
