OPERATION | ||
|
|
|
FIGURE B.1a
2
1 
3
DO NOT SWITCH
WHEN WELDING
PRO 100
FIGURE B.1b
4
WELDING OPERATIONS
SEQUENCE OF OPERATION
Wire Loading
Refer to Figure B.2 AND B3.
The machine power switch should be turned to the OFF (“O”) position before working inside the wire feed enclosure.
The machine is shipped from the factory ready to feed 4” (100 mm) diameter spools. A 4" (100 mm) diameter spool is mounted directly on the 5/8" (16 mm) diame- ter spindle that has a
Wire Spindle Shaft | 4" Wire Spool |
|
Wing Nut
and Spacer
To wire drive
FIGURE B.2
To use 8" (200 mm) diameter spools, the 2" (51 mm) diameter M15445 spindle must be used. Remove the spacer and wing nut at the end of the shaft. Insert spindle as shown in figure B.3. Reattach spacer and wing nut.
Note: When loading and removing the 8” Spools make sure that the wing nut (inside the wire spool spindle hub) is turned 90° from the wire spool spindle locking tab. If the wing nut is positioned in line with the locking tab, the tab cannot be depressed to load or unload the wire spool.
Make certain the start end of the wire, which may pro- trude through the side of the spool, does not contact any metallic case parts.
FIGURE B.3
Optional |
|
Wire Spool Spindle | Locking Tab |
8” Wire Spool
Be sure that this stud engages the hole in the wire spool.
To Wire Drive
Wire Spool must be pushed all the way on the spindle so that the spindle’s tab will hold it in place. The Wire Spool will rotate clock- wise when wire is dereeled.
PRO 100
