| INSTALLATION | ||
|
|
|
|
Read entire installation section before starting | FIGURE A.1 | ||
installation. |
|
| |
SAFETY PRECAUTIONS
WARNING
ELECTRIC SHOCK can kill.
•Only qualified personnel should perform this installation.
•Only personnel that have read and under- stood the PRO 100 Operating Manual should install and operate this equipment.
•Machine must be plugged into a receptacle which is grounded per any national, local or other applicable electrical codes.
•The PRO 100 power switch is to be in the OFF (“O”) position when installing work cable and gun and when connecting power cord to input power.
1 | 2 |
|
4
3
IDENTIFY AND LOCATE
COMPONENTS
If you have not already done so, unpack the PRO 100 from its carton and remove all packing material around the PRO 100. Remove the following loose items from the carton (see Figure A.1):
1.PRO 100
2.Gun and cable assembly(1)
3.Literature and miscellaneous including:
a)This operating manual
b)Extra .035" contact tip
c)Hex key wrench for removal of drive roll.
4.10 ft (3,0 m) work cable.
5.Work clamp.
6.Sample spool of Innershield .035" (0,9 mm)
7.Handshield with filter plate and lens.
8.Instructional video.
For available options and accessories refer to the Accessories Section of this manual.
(1)The gun is ready to feed 0.035" (0,9 mm) Inner- shield wire.
56
78
PRO 100
