Lincoln Electric IM843-C manual PRE-OPERATION Service, Vehicle Mounting, OIL Fuel, Cooling System

A-4 INSTALLATION A-4

TRAILER (See Optional Features)

If the user adapts a non-Lincoln trailer, the user must assume responsibility that the method of attachment and usage does not result in a safety hazard nor dam- age the welding equipment. Some of the factors to be considered are as follows:

1.	Design capacity of trailer vs. weight of Lincoln
	equipment and likely additional attachments.
2.	Proper support of, and attachment to, the base of
	the welding equipment so there will be no undue
	stress to the framework.
3.	Proper placement of the equipment on the trailer to
	ensure stability side to side and front to back when
	being moved and when standing by itself while
	being operated or serviced.
4.	Typical conditions of use, i.e., travel speed, rough-
	ness of surface on which the trailer will be operat-

	RECOMMENDED COPPER CABLE SIZES
			Cables Sizes for Combined Length
			of Electrode Plus Work Cable
Amps		Duty Cycle	Up to 200ft.(61m)	200 to 250ft.
				(61 to 76m)
250		100%	1	1/0
300		60%	1/0	2/0

PRE-OPERATION SERVICE

CAUTION

READ the engine operating and maintenance instruc- tions supplied with this machine.

------------------------------------------------------------------------

WARNING

ed; environmental conditions, likely maintenance.

5. Conformance with federal, state and local laws. (1)

(1) Consult your federal, state and local laws regarding specific

requirements for use on public highways.

VEHICLE MOUNTING

WARNING

Improperly mounted concentrated loads may cause unstable vehicle handling and tires or other components to fail.

DIESEL FUEL

can

cause fire

•Stop engine while fueling.

•Do not smoke when fueling.

•Keep sparks and flame away from tank.

•Do not leave unattended while fueling.

•Wipe up spilled fuel and allow fumes to clear before starting engine.

•Do not overfill tank, fuel expan- sion may cause overflow.

•Only transport this Equipment on serviceable vehicles which are rated and designed for such loads.

•Distribute, balance and secure loads so vehicle is stable under conditions of use.

•Do not exceed maximum rated loads for compo- nents such as suspension, axles and tires.

•Mount equipment base to metal bed or frame of vehicle.

•Follow vehicle manufactureʼs instructions.

------------------------------------------------------------------------

POLARITY CONTROL AND CABLE SIZES

With the engine off, route the electrode and work cables through the strain relief bracket on the base and connect to the studs located below the fuel tank mounting rail. (See size recommendations below.) For positive polarity, connect the electrode cable to the terminal marked “+”. For Negative polarity, con- nect the electrode cable to the “-”stud. These con- nections should be checked periodically and tightened if necessary.

When welding at a considerable distance from the welder, be sure you use ample sized welding cables.

DIESEL FUEL ONLY

------------------------------------------------------------------------

OIL

This unit is supplied from the factory with the engine crankcase filled with a high quality SAE 10W/30 oil. This oil should be acceptable for most typical ambient temperatures. Consult the engine operation manual for specific engine manufacturerʼs recommendations. Upon receipt of the welder, check the engine dipstick to be sure the oil is at the “full” mark. DO NOT overfill.

FUEL

Fill the fuel tank with the grade of fuel recommended in the Engine Operatorʼs manual. Make sure the valve on the water separator is in the open position.

COOLING SYSTEM

The radiator has been filled at the factory with a 50-50 mixture of ethylene glycol antifreeze and water. Check the radiator level and add a 50-50 solution as needed (see engine manual or antifreeze container for alternate antifreeze recommendations).

CLASSIC 300D KUBOTA