INSTALLATION |
GENERAL DESCRIPTION
The CLASSIC® 300D KUBOTA is a heavy duty, engine driven, DC arc welding power source, capable of providing constant current output for stick welding or DC TIG welding. This welder is wound with all cop- per coils, rated at 300 amps/32 Volts, and provides other Classic features such as improved door latches and stainless hinges. With the addition of the optional
The CLASSIC 300D KUBOTA has an Electronic Engine Protection System. In the event of sudden low oil pressure or high coolant temperature, the engine immediately shuts down. The CLASSIC 300D KUBO- TA has a current range of
RATED OUTPUT | DUTY CYCLE | ||
|
|
|
|
250A | @ | 30V | 100% |
300A | @ | 32V | 60% |
|
|
|
|
|
|
|
|
These units are also capable of providing 3 kVA of 115/230 volts of 60 cycle AC auxiliary power.
The CLASSIC 300D KUBOTA uses the Kubota V2203M industrial
DESIGN FEATURES
Control Panel
Both the engine and the welder controls are located on one recessed panel at the exciter end of the machine. The welder controls consist of a five step “Current Range Selector” switch and a “Fine Current Adjustment” rheostat. The welder is equipped with a “Start” button, an “Ignition” switch, an “Idler” control switch, and a “Glow Plug” button for easier cold weather starting.
The control panel also contains an engine tempera- ture gauge, a battery charging ammeter, an oil pres- sure gauge, two three prong grounding type recepta- cles and circuit breakers for auxiliary power.
All Copper Windings - For long life and dependable operation.
Engine Idler - The Classic 300D is equipped with an electronic automatic engine idler. It automatically increases and decreases engine speed when start- ing and stopping welding or using auxiliary power. A
Auxiliary Power - 3.0 kVA of nominal 115/230V, 60Hz, AC. Output voltage is maintained within ± 10% at all loads up to rated capacity. (See Optional Features for Power Plug Kit.)
Welder Enclosure - The complete welder is rubber mounted on a rugged steel “C” channel base.
The output terminals are placed at the side of the machines so that they are protected by the door. The output terminals are labeled (+) and
Cranking System - A 12 volt electric starter is stan- dard.
Air Cleaner - Heavy duty two stage dry type.
Muffler - A muffler and stainless steel exhaust outlet elbow are standard.
Engine Hour Meter - A meter to record hours of oper- ation.
Engine Protection - The system shuts the engine down in the event of sudden low oil pressure or high coolant temperature. A warning light on the control panel will indicate such a fault. To reset the engine for restarting, turn the ignition switch off then on.
Refer to Troubleshooting section for all warning light fault codes.
High Idle RPM (OCV) Adjustment - A Potentiometer is mounted on the Control Panel that allows the oper- ator to adjust the high idle engine speed between 1650 and 1800 RPMʼS. This is to allow further adjust- ment of the OCV. Total OCV adjustment range is about 15 volts.
Oil Drain Valve - A ball valve, hose and clamp are standard.
Remote Control - The Remote/Local switch and Receptacle are standard.
GFCI Receptacle - One UL approved 115V ground fault circuit interupter duplex type receptacle is stan- dard on codes 11243 and above. See MAINTE- NANCE section for detailed information on testing and resetting the GFCI receptacle.
