Lincoln Electric IM972 manual Stacking, Tilting, Oil, Lifting, PRE-OPERATION Engine Service

Models: IM972

1 35
Download 35 pages 12.64 Kb
Page 10
Image 10

A-3

INSTALLATION

A-3

STACKING

OUTBACK™ 185 machines CANNOT be stacked.

TILTING

Place the machine on a secure, level surface whenev- er you use it or store it. Any surfaces you place it on other than the ground must be firm, non-skid, and structurally sound.

The gasoline engine is designed to run in a level posi- tion for best performance. It can operate at an angle, but this should never be more than 15 degrees in any direction. If you do operate it at a slight angle, be sure to check the oil regularly and keep the oil level full. Also, fuel capacity will be a little less at an angle.

OIL

The OUTBACK™ 185 is shipped with the engine filled with SAE 10W30 oil. CHECK THE OIL LEVEL BEFORE YOU START THE ENGINE. This is an added precaution. Do not screw in dipstick when checking oil level. DO NOT OVERFILL. Be sure the fill plug is tight after servicing.

FUEL

Fill the fuel tank with clean, fresh, regular grade (mini- mum 87 octane lead free gasoline. DO NOT MIX OIL WITH GAS. The OUTBACK™ 185 capacity is approx- imately 6.8 gallons (25.74 Liter). DO NOT OVER- FILL, allow room in the fuel tank for fuel expansion.

LIFTING

The OUTBACK™ 185 should be lifted by two people. (See Specification section for weight). The LowLift™ grab bars on both ends make lifting easier.

PRE-OPERATION ENGINE SERVICE

Read and understand the engine operating and

maintenance instructions supplied with this machine

before you operate the OUTBACK™ 185.

WARNING

Keep hands away from muffler or HOT engine parts.

Stop the engine when fueling.

Do not smoke when fueling.

Remove fuel cap slowly to release pressure.

Do not overfill tank.

Wipe up spilled fuel and allow fumes to clear before starting engine.

Keep sparks and flame away from tank.

------------------------------------------------------------------------

SPARK ARRESTER

Some federal, state or local laws may require gaso- line engines to be equipped with exhaust spark arresters when they are operated in certain locations where unarrested sparks may present a fire hazard. The standard muffler included with this machine does not qualify as a spark arrester. For areas requiring spark arrestors, use K2793-1.

CAUTION

An incorrect additional arrester may lead to dam- age to the engine or adversely affect performance.

------------------------------------------------------------------------

OUTBACK™ 185

®

Page 10
Image 10
Lincoln Electric IM972 manual Stacking, Tilting, Oil, Lifting, PRE-OPERATION Engine Service, Spark Arrester