Drive Roll Installation/Removal
NOTE: Neither of the handles needs to be removed to access the Drive
or Idler Rolls.
Cam Lever 
1.Pull the Cam Lever away from the idler roll. This will relieve the pressure against the drive roll (as shown in Figure 1).
Figure 1
2.Align the Drive Roll Removal Tool (P/N
Figure 2
3.Once the drive roll is loose, continue to spin drive roll in the clockwise direction to remove the drive roll from the torch.
4.Install a new drive roll on the
Idler Roll Installation and Removal
(Reference Figure 3)
1.Using a slot type screwdriver, loosen idler screw, taking care not to lose lock washer under idler roll.
2.Insert new idler roll and lock washer onto screw, insuring that idler groove is toward top and lock washer is beneath.
Figure 3
3.Tighten.
NOTE: Lock washer must be under idler roll or it will not turn freely.
