Lincoln Electric K2447-2, K2447-3, K2447-1 Troubleshooting Guide, Testing The Gun, Motor Check

Troubleshooting Guide

Regardless of which torch or feeder used, all MK Products’ push-pull guns operate on the same principle. The slave motor in the feeder runs at a fast, constant speed, but has very low torque. It is always trying to feed more wire than the torch motor wants, and when the motor gets all it wants, it slows the slave motor, preventing a bird’s nest. Because of the low torque produced by the slave motor, a brake system is used to prevent wire overrun rather than tension. The drag adjustment in the feeder is used simply to keep the wire slightly taut, so it will not pull off the spool while feeding wire.

The high torque 24VDC torch motor is controlled by a solid state speed control located in the feeder, and a pot located in the torch. The torch motor, potentiometer, and micro switch are connected to the cabinet/control box via a control cable and Amphenol connector. If this cable becomes damaged, a variety of symptoms can occur, depending on which wire(s) break. To test, check each wire for continuity and shorts.

Remember, the micro switch in the torch activates both the slave motor and torch motor circuits in the cabinet. Therefore, if the slave motor and brake solenoid operate, but the torch does not, look more toward the torch motor’s 24V circuits, speed control, control cable, or the torch motor. If nothing operates, look more toward the slave motor’s input, micro switch leads, or micro switch.

Testing The Gun

Reference the "W" clocked torch wiring diagram on the Python® Electrical Diagram for information about pin-outs and locations.

Motor Check

Remove the torch connector from the cabinet.

Using the torch Amphenol connector, check the resistance across pins “A” and “B” (motor leads). The resistance across the motor should be between 5 - 10 ohms as the potentiometer is turned.

If an open circuit or short exist, check the motor leads and motor independently.

Testing the Potentiometer - “W” Clocked

Using the torch Amphenol connector, check the resistance across pin “D” (wiper) and pin “C”. The resistance should vary from 0 - 5K ohms as the potentiometer is turned.

Check the resistance across pin “D” (wiper) and pin “G”. The resistance should vary from 5K - 0 ohms as the potentiometer is turned.

Testing the Micro Switch

Using the torch Amphenol connector, check for continuity across pins “E”

and “F” when the trigger is pressed.

Python-Plus Owner's Manual - Page 9