| LINDY NetCam |
User Manual | English |
Benutzerhandbuch | Deutsch |
|
|
LINDY No. 32444
www.LINDY.com
© LINDY ELECTRONICS LIMITED &
English Manual
Introduction
Please check the package contents before proceeding, you should find the following items included.
1.The LINDY NetCam
2.Power supply unit
3.Mounting bracket
4.I/O Terminal block connector
5.This user manual
6.
Description and Installation
The following elements can be found on the front of the camera: The lens, the microphone and the status LED. On the back panel you can find: the power connector, the I/O terminal block, the Ethernet jack and the label containing the serial number. To connect the camera via a hub to an existing network, please use a standard 1:1 patch cable, to connect it directly to a PC, please use a crossover patch cable. If you wish to connect any external components (e.g. sensors/ alarms) then please refer to user manual on the
Setting the IP Address for the Camera
Please record the serial number from the label on the unit. This serial number is the MAC address for the camera, for example 0002D11000520 =
1.By using the ‘Installer.exe’ software on the
Run the ‘Installer.exe’ first, then power on the unit.
Click on the serial number that corresponds to your
camera
Assign a free IP address
If you want to fix the IP address of the unit, check the option ‘Use this IP whenever the
system boots’
Click ‘Set IP Address’ to start the installation process
English Manual
2.By using the DOS command line under Windows
Start a DOS Window and type the following commands:
Syntax: |
| arp |
|
| ping <IP address> |
|
| |
Example: |
| |
Type the arp command and press ‘enter’
Type the ping command and press ‘enter’
If you see the reply message, the unit has been installed successfully
Viewing the Camera via a Web browser
Type the IP address that you’ve assigned. The required password is the serial number (mind upper and lower cases), the login name is ‘root’
Click on the ’Configuration’ button for further adjustments
