Hard Disk Installation
1.Use a screwdriver to loosen the two screws on the rear panel.
Screws
2.Grab the front panel and pull the chassis out of the case.
3.Please ensure that the jumper on your hard drive is set to the Master position.
Note: refer to your Hard Disk manual for the location of the jumper!
4.Insert the IDE connector into the IDE socket on the Hard Disk. Make sure that pin 1 on the cable connects to pin1 on the hard disk. The location of pin 1 can be identified by the red strip on the edge of the cable. The IDE cable is ‘keyed’ to fit correctly into most hard drives.
IDE Connector
Page 12
