USB Root Hub
The driver has started correctly.
4.Double click on 'SCSI and RAID Controllers', if there is no yellow '!' or '?' in front of 'Silicon Image SiI 3112 SATARaid Controller' the driver has started correctly.
5.To view information about the devices attached to the controller, right click the 'Devices' and select Properties from the context menu, then select the tab labeled 'General'.
4.5. Windows 98 SE /ME Fresh OS installation
Follow the instructions in this section if you are performing a new installation of Windows 98SE/ME, and you wish to boot from a device attached to the SATA port.
You may start up the Windows 98SE/ME installation from CD. If either your Windows 98SE/ME CD or
1.Power off the system. Insert Combo card into an available PCI slot. Connect serial ATA cable(s) between the SATA port and serial ATA device(s). Power up the system.
2.Put your Windows 98SE/ME CD into the
3.Follow the normal Windows 98SE/ME setup instructions to select your choice for partition and file system.
4.Wait until Windows 98SE/ME finishes installing devices, regional settings, networking settings, components, and final set of tasks, reboot the system.
5.After the system reboots, right click on 'My Computer' and select 'Properties'. From 'System Properties ', select 'Device Manager', right click on the '?PCI RAID controller' and select 'Properties' from the context menu.
6.Click 'Driver', 'Update Driver' and select 'Automatic search for a better driver [Recommended] '. Insert the driver diskette into floppy drive. Click 'Next' and complete the driver installation.
7.System will go through the enumeration process and install the driver. At the end of the process, click 'Yes' to reboot your system.
8.See instructions in section 4.8 to verify controller was installed correctly.
4.6. Windows 98SE installation
1.Power off the system. Insert Combo Card into an available PCI slot. Power up the system.
2.During the system boot up, the Hardware Wizard will display that it found a 'PCI
- 8 -
