Line 6 AXSys 212 A

Appendices

AxSys 212 UserÕs Manual 39

APPENDICES

If you are experience problems while operating the AxSys 212, please use

the following table to locate possible causes and solutions before

contacting Line 6 customer service for assistance.

Symptom Cause Solution

The display does not light

when the POWER switch

is turned on.

No power. Check that the power cable is

plugged in properly.

No sound. Speakers are not

connected to amp.

Connect the speaker cables to

the rear panel LEFT

SPEAKER and RIGHT

SPEAKER jacks

Bad cable. Check your guitar cables;

replace if necessary.

Volume is turned down. Raise the MASTER knob.

Control Knobs wonÕt

change parameter settings.

Compare mode is turned

on (C appears in display)

Press COMPARE to exit

Compare mode.

Cleaning

Disconnect the AC cord, then use a damp cloth to clean the ampÕs metal

and plastic surfaces. For heavy dirt, use a non-abrasive household cleaner

such as Formula 409 or Fantastik. DO NOT SPRAY THE CLEANER

DIRECTLY ONTO THE FRONT OF THE UNIT AS IT MAY DAMAGE

THE LUBRICANTS USED IN THE SWITCHES AND CONTROLS! Spray

onto a cloth, then use the cloth to clean the unit.

Maintenance

Here are some tips for preventive maintenance.

¥ Periodically check the AC cord for signs of fraying or damage.

¥ Place a dust cover over the AxSys 212 when it is not in use.

Refer All Servicing to Line 6

We believe that the AxSys 212 is one of the most reliable amps that can be

made using current technology, and should provide years of trouble-free

use. However, should problems occur, DO NOT attempt to service the

amp yourself. The full AC line voltage, as well as high voltage/high

current DC voltages, are present at several points within the chassis.

Service on this product should be performed only by qualified technicians.

THERE ARE NO USER-SERVICEABLE PARTS INSIDE.