Line 6 AXSys 212 T

Chapter 2: The Guided Tour

8 AxSys 212 User Manual

Stereo Line Out

If you want to connect the AxSysÕ output to another amp, or into a mixing

board, connect a stereo TRS (tip-ring-sleeve) cable to the HEADPHONE /

STEREO LINE OUT jack on the rear panel. This jack provides a stereo line

level output. If you want to use the STEREO LINE OUT without the internal

speakers playing as well, disconnect the speakers.

When you connect a cable to the HEADPHONE/STEREO LINE OUT jack , the

AxSys automatically enables its Speaker Emulator which simulates the frequency

response of the speakers and the cabinet. However, if you leave the AxSysÕ internal

speakers connected while using the HEADPHONE/ STEREO LINE OUT jack , the

speakers will sound noticeably darker.

TIP If you want to turn off the automatic Speaker Emulator when you

use the HEADPHONE/STEREO LINE OUT jack, hold down the Row

Select button labeled GRAPHIC EQ and TREMOLO/CAB while turning on

the amp (we chose that button because it corresponds to the

Cabinet parameters, which makes it easier to remember). The

display will temporarily flash HPn and OFF to indicate that the

Headphone Speaker Emulator has been temporarily disabled. To

enable it again, turn the amp on again without holding any buttons.

Once all connections are made, turn down the MASTER volume and power

up the AxSys 212 with the POWER switch located on the AxSys rear panel

over the power cord.

The display should look something like this:

P01

This means that Preset Sound Bank 01 is selected.

After power-up, the AxSys will recall the Sound that was selected before it

was last turned off. The display will indicate the current:

¥ Mode: Preset, User or Edited

¥ Sound Bank: 01 through 32

...and one of the four SOUND LEDs (▼) will be lit to indicate the current:

¥ Sound: A, B, C or D