Linear AE-500 manual 63#TONE#, 64#TIME#, 65#POS#

System Options (Continued)

Speaker Tone on Relay Channel “A” Activation

The factory setting will not cause the speaker to sound a tone when access is granted with Relay Channel “A”. The tone can be turned on if desired.

1.If not already in Programming Mode, connect by telephone or use the local keypad. Enter the master password and access programming.

2.Press

3. Select the option for relay activation tone:

•Enter 0 to turn OFF the relay activation tone.

•Enter 1 to turn ON the relay activation tone.

4.Press

5.Exit Programming Mode if all programming is complete.

SPEAKER TONE ON RELAY "A" PPN 63

63#TONE#

TONE = 0 FOR RELAY TONE OFF

TONE = 1 FOR RELAY TONE ON

FACTORY SETTING: RELAY TONE OFF

Maximum Visitor Talk Time

Visitors will converse with residents over the telephone until the resident grants or denies access. If the resident responds to the visitor’s request by pressing their telephone keys the system will hang up and release the telephone line. If for some reason the resident does not press the telephone keys or does not hang up, the system will automatically disconnect the visitor after 60 seconds. The disconnect time can be adjusted from 15-255 seconds.

1.If not already in Programming Mode, connect by telephone or use the local keypad. Enter the master password and access programming.

2.Press

3. Enter the disconnect time in seconds (15-255):

4.Press

5.Exit Programming Mode if all programming is complete.

MAXIMUM VISITOR TALK TIME PPN 64

64#TIME#

TIME = TIME UNTIL AUTO-DISCONNECT

(15-255 SECONDS)

FACTORY SETTING: 60 SECONDS

Directory List Start Position

Although the directory is always sorted and displayed to visitors alphabetically, the initial directory entry displayed when # is pressed can be set to either the

first directory entry or the directory entry in the middle of all directory entries, alphabetically.

1.If not already in Programming Mode, connect by telephone or use the local keypad. Enter the master password and access programming.

2.Press

3. Select the option for the directory list start position.

•Enter 0 to start at the fi rst directory list

•Enter 1 to start in the middle of the directory list

4.Press

5.Exit Programming Mode if all programming is complete.

DIRECTORY LIST START POSITION PPN 65

65#POS#

POS = 0 to show first directory entry

POS = 1 to show the middle directory entry

FACTORY SETTING: 1 (SHOW MIDDLE DIRECTORY ENTRY)

13