EtherFast Cable/DSLRouters
USB The USB LED lights up when the USB port is successfully
connected to a PC, USB hub, or other USB device.
The WAN Indicators
Link Green. The Link LED lights up when a successful connec-
tion is made between the Router and your broadband device
or network.
Act Green. The Act LED flickers when the Router is sending or
receiving data over the broadband WAN port.
Diag Red. The Diag LED lights up when the Router goes through
its self-diagnostic mode. It will turn off upon successful
completion of the diagnosis.
If this LEDstays on for an abnormally long period of time,
see the Troubleshooting section.
14
Instant Broadband Series
Buttons
The Reset Button Details on the Resetbutton are found in the Getting
to Know the 4-Port EtherFast Cable/DSLRouter
section.
The 3-Port Router’s Front Panel LEDs
The LAN Indicators
Power Green. The Power LED lights up green when the Router is
powered on.
Link/Act Green. The Link/ActLED serves two purposes. If the LED
is continuously lit up, the Router is successfully connected to
a device through the corresponding RJ-45 port (1, 2, or 3). If
the LED flickers, then that port is sending or receiving data
to and from the network.
Full/Col Green. The Full/Col LED also serves two purposes. If this
LEDis continuously lit up, the connection made through the
corresponding port is successfully running in Full Duplex
mode. If the LEDis flickering, the connection is experien-
ing collisions. Infrequent collisions are normal.
If this LED flickers too often, there may be a problem with
your connection. See the Troubleshooting section if you have
problems.
100 Orange. The 100 LED lights up when a successful 100Mbps
connection is made through the corresponding port. If this
LED does not light up, then your connection speed is 10
Mbps.
13