EtherFast Cable/DSLRouters
50
Instant Broadband Series
49
If your Cable/DSL Router is connected to more than one network, you may
have to set up a static route between the two networks. A static route is a pre-
determined pathway that network data packets must travel to reach a specific
host or network. Click the Show Routing Table button to view the current
static routing configuration.
To create a static route entry:
Static Routing
With Dynamic Routing, you can automatically adjust to physical changes in
the network's layout. The Router, using the RIPprotocol, calculates the most
efficient route for the network’s data packets to travel between the source and
the destination, based upon the shortest paths. The RIP protocol regularly
broadcasts routing information to other routers on the network.
To set up dynamic routing:
1. Select the correct working mode. Gateway Modeshould be used if your
Router is hosting your network's connection to the Internet. Router Mode
should be selected if the Router exists on a network with other routers.
2. Select the protocol(TX) by which you transmit data on the network.
3. Select the protocol(RX) by which the Router receives network data.
4. Click the Applybutton to save your changes.
Static Rou
Dynamic Routing