23
ProConnect II
®Series
22
Layer 2 Management 4-Port Gigabit Ethernet Switch
Returning to the Basic Management Screen
After completing the general management activities, press the Esckey to exit
the General screen and return to the Basic Managementscreen. You can then
select another option from the Basic Management screen or press Escto
return to the Switch Management screen.
Console Port Configuration
Select Console Portfrom the Basic Management screen, the Console Port
Configurations screen will appear, with the Baud Ratevalue highlighted.
Use the procedures in this section to configure the Console Port
Configurations options for one or more settings, including:
• Specifying Baud Rate
• Specifying Flow Control
• Enable or Disable Modem Control
• Enter Modem Setup String
• Enable or DisableSLIP
• Specify a Slip Address
• Specify a SLIP Subnet Mask
Changing the Flow Control
1. With the Speed & Flow Cntl Optionsscreen displayed, press the Down
Arrow key to highlight Flow Control and press Enter. The Flow Cntl
Options screen will appear.
2. Highlight the desired flow control option for the port. Autoallows the
Switch to automatically determine whether or not to use flow control. On
enables flow control at all times. Offdisables flow control at all times.
3. Press Enter. You will return to the Speed & Flow Cntl Options screen,
and the selected flow control setting will appear next to Flow Control.
4. To configure the flow control for additional ports, press Escto remove
the Speed & Flow Cntl Options screen. Highlight the desired port then
press Enter. Highlight Speed and Flow Control, then press Enter.Repeat
steps 1 through 3 for each additional port.
5. When you are finished, press the Esckey from the Line Speed & Flow
Control screen to return to the LAN Port Configurationsscreen.
Admin Control
1. From the Port Settings Optionsmenu, select Admin Control and press
the Enter key.
2. The Admin Status Options menu will appear.
3. Select Up to allow administration of the Switch per port or Downto disallow.
Displaying Physical Port Address
The following procedure describes how to display the physical address of the Switch.
1. From the LAN Port Configurationsscreen, highlight Physical Address and press
the Enter key. A screen similar to the following (see next page) will appear.