![](/images/new-backgrounds/1117359/11735919x1.webp)
Chapter 2 | Product Overview |
CONSOLE The Switch is equipped with a serial port labeled Console (located on the back of the switch) that allows you to connect to a computer’s serial port (for configuration purposes) using the provided serial cable. You can use HyperTerminal to manage the Switch using the console port.
Refer to Chapter 4: Configuration Using the Console Interface for more information.
NOTE: If you need to reset the Switch, unplug the power cord from the back of the Switch. Wait a few seconds and then reconnect it.
SRW2024
Front Panel
The Switch’s LEDs and ports are located on the front panel.
Front Panel of the SRW2024
LEDs
POWER (Green) Lights up green to indicate that power is being supplied to the Switch.
LINK/ACT
ETHERNET
MiniGBIC
Use the Linksys MGBT1, MGBSX1, or MGBLH1 miniGBIC modules with the Switch. The MGBSX1 and the MGBLH1 require fiber cabling with LC connectors, while the MGBT1 requires a Category 5e Ethernet cable with an
NOTE: On the SRW2024, MiniGBIC ports are shared with standard ports. If a miniGBIC port is used, then the shared standard port on the Switch cannot be used. The following table provides port mapping details of the SRW2024 Switch.
SRW2024 Shared Port Mapping
miniGBIC Port | Standard Port |
|
|
miniGBIC 1 | Port 12 |
miniGBIC 2 | Port 24 |
|
|
Back Panel
The power port is located on the back panel of the Switch.
Back Panel of the SRW2024
POWER The Power port is where you will connect the AC power.
WebView Switches | 3 |