Chapter 4 | Installation |
Connecting the Access Point
1.Connect the antennas to the antenna connectors on the Access Point.
Connect the Antennas
2.Adjust the two antennas so that they form a 90 degree angle for best performance.
Adjust the Antennas
3.Connect your Ethernet network cable to your network router or switch.
LINK/ACT | PoE | LINK/ACT |
|
| PoE | LINK/ACT | Gigabit | LINK/ACT | Gigabit |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Connect the Ethernet cable to the Router or Switch
4.Connect the other end of the network cable to the Access Point’s Ethernet port.
Connect the Ethernet cable to the Access Point
NOTE: If your router or switch provides Power over Ethernet, then step 5 is not necessary.
5.If you are not using PoE (Power over Ethernet), then connect the included power adapter to the Access Point’s Power port. Then plug the power adapter into an electrical outlet. The LEDs on the front panel will light up as soon as the Access Point powers on.
Connect the Power
Installation is complete. For advanced configuration
information, proceed to the next chapter.
