Linksys WAPPOE manual Power on a Device that Uses a Standard Power Adapter

Chapter 2

Connection

Power on a Device that Uses a Standard

Power Adapter

Use the Injector and Splitter to power up a device that uses a standard power adapter. Follow these instructions:

1.Connect the Injector’s built-in Ethernet network cable to your router, switch, or other network device.

2.Connect the Kit’s included Ethernet network cable to the Injector’s Power & Data OUT port.

NOTE: If this cable is not long enough, then you can use your own Ethernet network cable.

3. Then connect the other end to the Splitter’s Power & Data IN port.

4.Connect the Splitter’s built-in Ethernet network cable to the Ethernet port of your remotely located access point or other network device.

5.Connect the Splitter’s Power cord to the Power port of your remotely located access point or other network device.

	Power Over Ethernet Adapter Kit