Linksys WAPPOE manual Power on a Device that Uses Inline Power

Connection

Chapter 2

NOTE: If the plug of the Splitter’s Power cord does not fit into your network device, then use the included barrel jack adapter. Plug the Splitter’s Power cord into the jack end, and plug the other end of the barrel jack adapter into the Power port of your network device.

6.Connect the Kit’s power adapter to the Injector, and plug the other end into an electrical outlet or surge protector.

Congratulations! The installation of the Power Over Ethernet Kit is

complete.

Power on a Device that Uses Inline Power

Use only the Injector to power up a device that supports inline power. Follow these instructions:

1.Connect the Injector’s built-in Ethernet network cable to your router, switch, or other network device.

2.Connect the Kit’s included Ethernet network cable to the Injector’s Power & Data OUT port.

Power Over Ethernet Adapter Kit