Linn CD Playback System owner manual TO PLAY THE SELECTION YOU HAVE MADEpress PLAY, P - - b, P-00

DISPLAY until “P--A” appears. Then release DISPLAY and the display will show “P” followed by the number of program slots used. Enter the additional tracks using SKIP and DISPLAY as described previously. Press STOP o when you have finished adding tracks.

TO PLAY THE SELECTION YOU HAVE MADE press PLAY 2.

TO PREPARE TO PLAY THE SELECTION YOU HAVE MADE press PAUSE p. This is useful when you are making a tape. When you are ready to listen or record, press PAUSE p again or PLAY 2 to start your selection.

TO ADD MORE TRACKS TO THE PROGRAM after it is playing press STOP o. You can now check or add to the program as described above.

TO CANCEL THE PROGRAM press OPEN. The program is now cleared.

TO OMIT A SET OF TRACKS make sure the disc is loaded but not playing. Press and hold the button marked DISPLAY for about 4 seconds until the display shows

P - - b

which indicates that programming mode b has been entered. Release DISPLAY, and the display will show

P-00

indicating that the KARIK is ready for you to enter to your selection. Enter tracks in the same way as for programming mode A. When you now play the disc the tracks you have entered will not be played.

NOTES ON PROGRAM MODE While the KARIK is playing a stored program the A-B REPEAT function is disabled and SKIP i or u SKIP will skip to the next or previous track in the programmed sequence. SEARCH y will search through the current track, and then into the next track in numerical, rather than program, sequence. So, you can use SEARCH y to break out of the stored program. If you do so though, the program will resume at the end of the track you used SEARCH y to get into.

17