iv
CE Declaration of Conformity
Linn Products Ltd declare that this product is in conformance with the Low Voltage Directive 73/23/EEC and Electromagnetic Compatibility 89/336/ EEC as amended by 92/31/EEC and 93/68/EEC.
The conformity of the designated product with the provisions of Directive number 73/23/EEC (LVD) is proved by full compliance with the following standards:
Standard number | Date of issue | Test type |
EN60065 | 1993 | General requirements |
|
| Marking |
|
| Ionizing |
|
| Heating under normal conditions |
|
| Shock hazards under normal |
|
| operating conditions |
|
| Insulation requirements |
|
| Fault conditions |
|
| Mechanical strength |
|
| Parts connected to the mains supply |
|
| Components |
|
| Terminal devices |
|
| External flexible cords |
|
| Electrical connections and |
|
| mechanical fixings |
The conformity of the designated product with the provisions of Directive number 89/336/EEC (EMC) is proved by full compliance with the following standards:
Standard number | Date of issue | Test type |
EN55013 | 1994 | Conducted emissions |
EN55013 | 1994 | Absorbed emissions |
1987 | Harmonics | |
1987 | Voltage fluctuations | |
EN55020 | 1994 | Immunity |
FCC notice
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
