GENERAL SYSTEM INSTALLATION
TURNTABLES For best results a turntable should be placed on a small, light, rigid table, or alternatively wall mounted on a light, rigid shelf.
CD PLAYER The KARIK and NUMERIK should be positioned on a level surface. Extensive internal screening in the KAIRN
POWER SUPPLIES Take care not to position too close to signal leads, turntables or
AMPLIFIERS Pre and power amplifiers may hum is positioned too close together. For minimum hum, experiment by moving the components with the system at full volume but not playing music (although it is best to turn the volume down whilst actually moving the components). The KLOUT power amplifier has a screened transformer which enables it to be positioned close to other audio products in your system without interference. Position the KLOUT to allow free movement of air around the heatsinks. Do not stack a KLOUT with other products which will obstruct the airflow, or which cannot support the weight.
LOUDSPEAKERS Loudspeakers should be positioned correctly. They should be mounted on rigid stands and not subject to any rocking movement.
CLEAN CONTACTS It is important that the electrical contacts in a
WARNING This should be carried out after the mains supply has been switched off.
INTERCONNECT LEADS Correct cables should be used. We recommend good quality copper cable for interconnect leads and advise 4mm2 multicore copper cable, such as Linn K20, for speaker leads.
Your Linn dealer can supply high quality interconnects for linking all your
9
