Linn Stereo Pre-Amplifier User Options, Description, Possible settings, 100/+10dB, 0/- ∞ to

User Options

User Option	Description
MAX VOLUME	Upper limit on the volume control.
BINDING	If set to GLOBAL, the same volume and balance
	settings are used for each source. If set to
	PER SOURCE, separate volume and balance settings
	are allowed for each source.
PRODUCT IR	Enables or disables the infra-red receiver on the
	front of the unit.
REMOTE IR	Allows you to specify which remote infra-red device
	the unit responds to or disables operation of the
	unit via a remote infra-red device.
UNITS	Units in which volume level is displayed.
LOGO	The graphics used as the logo in the SLEEP DISPLAY
	option.
KEY RATE	Rate at which volume changes when VOLUME +/-
	keys are held.
MUTE RATE	Rate at which volume mutes/unmutes when
	switching sources or muting/unmuting.
BRIGHTNESS	Brightness of front panel display.
RS232 CONNECTION	Enables or disables the RS232 circuitry.
DEVICE ADDRESS	Which RC5 addresses the unit will respond to.
INSTALLER SETUP*	To reset the unit to the settings defined by the
	installer when the unit was first configured, set to YES.
FACTORY SETUP**	To reset the unit to the settings defined at
(only appears if installer	manufacture (i.e. the defaults shown in the
settings have been altered.)	right-hand column and a blank set of source
	setups), set to YES.

Possible settings

100/(+10dB), 0/(- ∞) to

100/(+10dB)

GLOBAL, PER SOURCE

ENABLED, DISABLED

RCU, NOTHING, MOGEYE

NUMERICAL, dB

Linn logo, musical notes

21, range 1 (slowest) to 40 (fastest)

3, range 1 (slowest) to 10 (fastest)

15, range 0 (dimmest) to

15 (brightest)

ENABLED, DISABLED HANDSET, 0x10, 0x13

NO, YES

NO, YES

*If set to YES, the unit will display names given to sources during initial source setup.

**To reset the factory defaults, you must first reset the installer settings (set INSTALLER SETUP option to YES) then exit and re-enter user options mode.

15