Little Wonder 2847 owner manual Chimney Connection, Repair Parts, Circulator, Heater

CHIMNEY CONNECTION

2	3
	8
	7
5
4
6
34

1

19

		14
		15
		12
13	10	36

AUTOMATIC COAL BURNING MODEL 2847 - INTERIOR	REPAIR PARTS
CIRCULATOR

Two basic types of chimneys are ap- proved for use with solid fuel: Factory- built and masonry. Factory-built chim- ney must comply with UL103HT stan- dard.

Do not expect your stove or furnace to create draft. Draft is not a function of the appliance. Draft is purely a function of the chimney. Modern stoves and furnaces are much more airtight and efficient than those of the past; and, therefore require greater draft. A minimum of .05, mea- sured in water column (gauges to mea- sure chimney draft are readily available at stove shops and are economical to purchase or rent) is required for proper drafting to prevent back-puffing, smoke spillage, and to maximize performance.

Chimneys perform two functions - one of which is apparent: The chimney pro- vides a means for exhausting smoke and flue

gases resulting from combustion of the fuel. Secondarily, though, the chimney provides "Draft" which allows oxygen to be continuously introduced into the appliance, so that proper combustion is possible. As of April 1, 1987, all heaters and furnaces manufactured by United States Stove Company should be installed using a factory built chimney that meets the "Type HT" requirement of UL 103 (when a factory - built chimney is used).

IMPORTANT

*Size the chimney to the flue outlet on the stove. (6" outlet = 6" I.D. chimney) *Avoid using elbows except as necessary (they reduce draft).

*Make sure all horizontal runs of connector pipe go up hill (1/4" elevation for each horizontal foot).

	2 FT MIN.
10 FT.	3 FT.
	MIN.

9

29 28	33	29	31 32
		28	27
		30	26

21		16	18
		11
			35
		17
24	25	20
	23
22

HEATER

FLUE CONNECTION - NON-COMBUSTIBLE WALL

THIMBLE

COLLAR

PIPE

ELBOW

PIPE

FLOOR PROTECTOR	NON-COMBUSTIBLE
	WALL

Fig. 5

Thru-the-Wall Installation

REFER TO CHIMNEY

MANUFACTURERS PARTS

AND INSTRUCTIONS

PIPE

FLOOR PROTECTOR

Fig. 6

20

5