LIGHTING INSTRUCTIONS
1.STOP! Read the safety information above.
2.Turn off all electrical power to the appliance.
3.Remove the upper front access panel
4.Turn the power switch on the inside of the cabinet to "OFF" position.
5.Set the thermostat to the lowest setting.
6.This appliance is equipped with an ignition device which automatically lights the burners. DO NOT try to light the burners by hand.
7.Turn the gas control knob on the gas valve clockwise to the "OFF" position.
FIG. 1 Combination Gas Valve
TO TURN OFF GAS TO APPLIANCE
1.Turn off all electric power to the appliance if service is to be performed.
2.Turn the gas control knob on the gas valve clockwise to the "OFF" position. Do not force.
WARNING
Should overheating occur or the gas fail to shut off, do not turn off or disconnect the electric supply to the pump. Instead, shut off the gas supply at a location external to the appliance.
HOT SURFACE IGNITION SYSTEM
The hot surface ignition module is not repairable. Any modification or repairs will invalidate the warranty and may create hazardous conditions that result in property damage, personal injury, fire, explosion and/or toxic gases. A faulty ignition module must be replaced with a new unit. The hot surface igniter is also the flame sensor.
Call a qualified service technician if service is required on the hot surface ignition system.
WATER CONNECTIONS
8.Wait five (5) minutes to clear out any gas. If you smell gas, STOP! Follow the instructions in the safety information "What To Do If You Smell Gas". If you don't smell gas, go on to the next step.
9.Turn the gas control knob on the gas valve counterclockwise to the "ON" position.
10.Set the thermostat to the desired setting.
11.Turn the power switch on the inside of the cabinet to the “ON” position.
12.Replace control access panel.
13.Turn on all electrical power to the appliance.
14.If the appliance will not operate, follow the instructions "To Turn Off Gas To Appliance" and call your service technician or gas supplier.
FIG. 2 Water Connections
Inlet and Outlet Connections
For ease of service, install unions on inlet and outlet of the appliance. The connection to the appliance marked "Inlet" on the header should be used for return from the system. The connection on the header marked "Outlet" is to be connected to the supply side of the system.
2
