Initial Set-up

After you have finished making the link, a message will appear on the screen.

Example 1 - successful link:

Sound components wizard

 

 

The transmitter and receiver module assignment has

 

 

 

 

been completed successfully.

50Hz

120Hz 50Hz

 

100Hz

100Hz

 

 

 

English

END

OK Proceed

Once the link has been made successfully, the LEDs in the transmitter and receiver module light up green continuously.

Example 2 - unsuccessful link:

Sound components wizard

 

 

 

The assignment of the transmitter and receiver

 

 

 

module was unsuccessful. You can try again with the

50Hz

120Hz 50Hz

 

OK button or exit the wizard with the END button and

 

 

 

restart it to change the speaker connection

 

 

 

configuration if necessary.

100Hz

100Hz

 

 

 

 

 

 

 

 

 

 

 

END

OK Start Transmitter - Receiver assignment

Confirm OK and if necessary make further settings or close menu.

Linking modules with other TV sets

With other TV sets (other chassis than L2710), configuration and connection are done manually. For this purpose, both modules have to be in connection status.

Make sure that the units are set up correctly (page 22). Depending on which TV set and accessories you are using, either the connections described on page 24 or 25 are to be made.

Press the SET button on the transmitter module (page 18) for at least 3 seconds.

The green LED on the transmitter module flashes quickly.

Now, within the next two minutes, press the SET button on the receiver module (page 19) for at least 3 seconds until the green LED display flashes quickly. Wait until the link is completed.

Once the link has been made successfully, the LEDs on the transmitter and receiver module light up green continuously.

You will find information on the LED displays on page 29.

For TV sets with AC3 module, in the menu Sound components under sound playback via ... select the option Speaker system.

Setting input sensitivity

You can set the input sensitivity on the transmitter module in three steps to adjust the volume to the input signal.

Briefly press the SET button on the transmitter module (page 18).

The volume can be adjusted by repeatedly pressing the SET button in the sequence 0 dB → -6 dB → -12 dB → 0 dB etc.

- 28