Loewe Mimo L 20 DVB-T Directing DVB-T antenna, Switch on from stand-by, Select a TV channel

Initial installation Daily operation

Directing DVB-T antenna

(only for DVB-T models)

If you use a room antenna to receive one or more DVB-T stations that have picture and sound interference, then you should change the location of where the antenna is set up.

To help you direct your antenna or to help you determine the most suitable loca- tion to set up the antenna, your TV set has a display for the signal quality C/N and the signal strength Level.

Consult your specialist dealer to find out which channels and frequency bands (VHF or UHF) are used to broadcast the digital TV stations in your area.

On any one channel, several digital stations are broadcast.

Select a TV channel

1.	Call the “TV menu“ via the MENU button.
2.	Use	to select “Settings“, then use					to select the menu line under-
	neath.
3.	Select “Channels“, then use				to select the menu line underneath.
				TV menu
				Settings
				Channels				INFO	END
			search	Manual settings		OK	Change		Autom
4.	Select “Manual settings“ and call the menu using OK

Switch on from stand-by

On the set:

If the LED on the set glows red or orange:

(	Press the display window to switch the set on.
	If the red LED on the set is not alight:
	Press the On / Off button (mains voltage) on the right hand
	side of the set.
	Switch to stand-by:
(	Press the display window, the LED changes colour from green
	to red.

Switch on/off with the remote control

The set is on stand-by, the red LED is alight:

Press the blue on/off button on the remote control to switch on the set or ...

AV

Manual settings

Signal source

Channel

Frequency

Name

C/N 96

DVB-T Antenna/cabl

E05

177.50 MHz Test

Level 99

Search END

StoreINFO

with a numeric key (0 – 9) or ...

wxyz

OK with the OK button.

The green operating LED then lights up.

5.For digital stations, select “Signal source – DVB-T“.

6.Use the numerical buttons to specify the corresponding channel number. When you receive a digital station, the system displays the signal quality C/N via a bar/numeric value and the signal strength via Level. The anten- na‘s direction or position is best when the largest values possible are displayed (long bar) for the signal quality and signal strength.

7.Direct the antenna so that the largest numerical value/bar size is reached.

8.If no signal is found in the channel set, you can start the frequency search run by pressing the blue button within the band selected (VHF or UHF).

9.Check the other channels one after another on which digital stations are broadcast terrestrially in your area.

For the weakest station, direct the antenna so that the maximum numerical value/bar size is achieved.

10.After you position or direct the antenna, we recommend to search for all the stations using the “Search wizard“ (TV menu – Settings – Channels – Auto-

matic search).

Downloaded From TV-Manual.com Manuals

Switch on radio mode: (see also page 18).

RADIO Press the Radio button.

Switch off radio mode:

RADIO Press the Radio button again or ...

END press the button END.

11 -