Instruction Manual | TOTAL TRIMMER | Model T300 &T360 |
|
|
|
Maintenance and Adjustment
Cutting Head Bearings
If cutting head is loose or wobbling, tighten three adjustment screws to eliminate the play and improve cut accuracy. (Fig. 12)
Resquare Squaring Arm
1.Place a carpenter’s square against cutting bar first. Slide against squaring arm and look for gaps between square and squaring arm. (Fig. 13)
2.Notice which way squaring arm would have to move to eliminate gap.
3.Remove squaring arm and locate two screws inside side slots. (Fig. 14)
4.To adjust, move each screw equal but opposite directions. Only adjust a small amount.
DO NOT ADJUST Tension Screw - Single screw on opposite side
5.Retest squareness.
Fig. 12
Adjustment Screws
Fig. 13 |
Carpenter’s Square |
Fig. 14 |
4
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084
L3326 1/10