MAINTENANCE

Bay Glass Removal

TO REMOVE FAN:

10) Unplug the wires from the fan motor (from

inside the stove).

1)Remove the door from the unit and place on a soft surface to prevent scratching.

2)Remove the nuts holding the glass retainers in place.

3)Remove the glass retainers (sides, top and bottom).

1)Turn the unit off and allow it to cool to room temperature.

2)Unplug or disconnect power source to stove.

3)Remove glass front (see section "Standard Flush Door.")

11)

Lift FanAssembly off of the 2 pins, tip forward

 

and pull through fi rebox opening.

12)

Disconnect green wire from power cord.

4) Replace the glass. The glass must have 4)

gasketing around it.

5)

5)Reverse the previous steps, replace the

retainers and fasten with the nuts but do not

6)

over tighten, as this can break the glass.

6)Replace door on the stove and check the seal.

7)

Remove logs and brick panels, if used.

Remove the grate by loosening the two screws and sliding the grate out.

Remove the burner/front log support assembly by removing the 2 screws and lifting it out.

Grate screws

Remove the 2 screws holding the Air Intake Hood to the rear fi rebox wall and lift out.

Replacing fan:

FAN MAINTENANCE

Ifyourfanrequiresmaintenanceorreplacement, access to the fan is through the plate on the rear wall of the fi rebox. NOTE: the unit MUST NOT be operated without the fan access panel securely in place.

Caution: Label all wires prior to disconnectingwhenservicingcontrols. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

8)Remove the 10 screws holding the Access Panel in place.

9)Remove the Fan Air Duct by loosening the 3 screws, squeeze the sides together to remove.

Reverse above steps. Hint for pushing fan down onto pins - rub a bit of dish soap on the grommet so it will slide more easily onto the pin.

Check to make sure the fan is seated properly on the pins, this is very important- try to move the fan back and forth, there should be no noise, if there is check that the grommets haven't come loose.

Seal fan access panel using high temperature silicone (sparingly).

32

U32-5 FPI Direct Vent Gas Insert

Page 31 Page 33
Page 32
Image 32
Hampton Direct U32 installation manual FAN Maintenance, Bay Glass Removal
Page 31 Page 33

U32 specifications

Hampton Direct U32 is a versatile and innovative product designed to enhance everyday living. This device serves as an all-in-one solution, combining functionality, convenience, and modern technology to meet the needs of today's consumers.

One of the standout features of the Hampton Direct U32 is its user-friendly interface. The device comes equipped with a high-resolution touchscreen display, allowing users to navigate through various functions effortlessly. This intuitive design ensures that individuals of all ages can operate the U32 without frustration or difficulty.

The U32 also boasts a range of connectivity options, including Bluetooth and Wi-Fi capabilities. This enables users to connect the device to their smartphones, smart home systems, or other peripherals, making it a seamless addition to any tech-savvy lifestyle. With the ability to sync with mobile applications, users can access a broad range of features, from remote control functions to personalized settings tailored to their preferences.

In addition to connectivity, the Hampton Direct U32 incorporates advanced technology such as voice recognition. This feature allows users to control the device hands-free, enhancing convenience and providing an intuitive experience. The voice command functionality can access various features, further simplifying routine tasks and fostering a more connected environment.

Moreover, the U32 is designed with energy efficiency in mind. Utilizing modern energy-saving technologies, this device minimizes power consumption while delivering reliable performance. It is not just about functionality; the U32 is built to be eco-friendly, appealing to environmentally conscious consumers who wish to reduce their carbon footprint.

Another remarkable characteristic of the Hampton Direct U32 is its durability. Constructed from high-quality materials, the device is designed to withstand daily wear and tear while maintaining optimal performance. This robustness ensures that users can rely on the U32 long-term, making it a worthwhile investment.

Overall, the Hampton Direct U32 stands out as a multifunctional device that combines cutting-edge technology, user-friendly design, and energy efficiency. It successfully addresses the demands of modern living by offering robust features that cater to convenience, connectivity, and sustainability, making it an essential tool for households looking to simplify and enhance their daily routines.
Top Page Image Contents