Lopi 864 ST Operation9, Adjusting the Optional Blower Speed, Normal Operating Sounds, High

Operation9

Adjusting the Optional Blower Speed

The blower helps transfer heat from the heater into the room. up to temperature (approximately 10 minutes after starting). instructions on adjusting the blower speed.

It will not turn on until the heater is See the illustration below for

OFF	HIGH	LOW
Turn the dial all the	The high position is all the	Turn the dial all the
		way clockwise.
way counter-clockwise	way counter-clockwise,
until it clicks off.	without clicking off.

Normal Operating Sounds

Blower Snap Disk

This part can produce a clicking sound as it turns the blower on and off.

Gas Control Valve

As the gas control valve is turned on and off you will hear a dull clicking sound. This is the valve opening up and shutting down.

The appliance may creak with change of temperature -- THIS IS NORMAL.

Extinction Pops

It is not unusual, especially on Propane (LP) appliances, to experience a "pop" when the burner is shut off.

Pilot Flame

The pilot flame, which remains on, makes a very slight "whisper" sound.

Blowers

This heater has optional blowers to push heated air into the room. You will hear the sound of air movement that increases as the speed is increased.

Normal Operating Odors

This appliance has several areas that reach high temperatures. Dust or other particles on these areas may burn and create an odor. This is normal during start-up. You may notice the smell is more acute if the appliance was left idle for a long period.

© Travis Industries 4071130 100-01196_000