6Operation
Before You Begin
•Read this entire manual before you use your new fireplace (especially the section "Safety Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or even death.
Location of Controls (front side only)
The Pilot Flame can be
found under the center log (it
is best viewed at a low level).
Pilot Igniter
ON/OFF Switch
Gas Control Valve |
|
Comfort Control | Flame Adjust Knob Gas Control Knob |
Lift the control cover up and swing it
forward to access the controls.
Optional Blower Control
Optional Accent Light
An instruction card for operating the fireplace is attached to the inside of the fireplace here. Replace it for easy reference.
Pilot Igniter | The pilot igniter is used only to start the pilot. | When pressed, it sends an |
| electrical charge to the pilot assembly. This creates a blue spark | |
| directly next to the pilot, igniting the pilot flame. | |
On/Off Switch | This control is used to turn the fireplace burners on and off. | |
Gas Control Knob | This knob is used to control gas to the fireplace and for starting the pilot. | |
| There are three positions, ON, OFF, & PILOT. The pointer to the left of | |
| the knob indicates the position this knob is in. |
|
Flame Adjust Knob | This knob controls the flame height from low ("LO") to high ("HI"). The | |
| pointer above the knob points to the position this knob is in. | |
Comfort Control | This lever turns the rear burner on and off. |
|
| NOTE: THIS IS NOT A SHUTOFF VALVE. |
|
Optional Blower Control | This knob controls the speed of the optional internal convection blower | |
| that pushes heated air into the room. |
|
Optional Accent Light | This knob controls the optional accent lights located behind the logs. | |
|
|
|
© Travis Industries | 4071130 | |
