4.BATTERY : Remove the Battery cover and insert one 9V alkaline battery.

5.ARM & HOLDER : For mounting on the wall.

6.BATTERY COVER

Replace the Battery

zWhen the sensor sends a low battery message to main console, remove the old battery and replace it with a fresh alkaline battery. The LCD is shown below

63 PIR SENSOR

01 Low battery

Zone Address Setting

Enter the Installer password and press “1” to activate the “Sequence Programming Menu” after installing the battery for the PIR sensor. Set the power switch from “ OFF ” to

C ” position. The red LED will blink for 1 second and activate the PIR sensor by moving in front of the PIR Sensor. The Main Console will emit one ‘Beep’ and the LCD will display, ‘Sensor Added’. The PIR sensor has been programmed into the main console successfully.

When the main console is in the armed mode, the PIR detects movement of human or animals (cat, dog). A message will be displayed on the LCD as shown below.

63 PIR SENSOR

01 Zone

Notes on the Position when Installed

The PIR Motion sensor detects the movement of humans and animals within their range. In order to prevent false alarms, we recommend that you do not install any motion sensor in the following areas:

Do not install any PIR motion sensor in the following areas:

zWhere there is a device that causes rapid temperature change or rapid heat transfer. For instance, near an air conditioner, fire place, heater or other intermittent heat sources.

zWhere the sensor will be exposed to direct sunlight.

zNear large electrical devices and/or high output radio frequency sources, like a refrigerator, microwave, computer, or light dimmer.

zWhere the effective range of the sensor is covered or blocked by furniture.

zWhere pets enter and exit freely, for instance - a cat or dog door.

zDirectly opposite any large object with flat reflecting properties, like large windows or mirrors.

zIn a bathroom or other area that is exposed to moisture and extreme temperature change.

Installing the PIR Motion Sensor

18