LOREX Technology LW2100 Series Receiver Function Buttons, Press the M to enter or exit Menu Mode

COLOR DIGITAL WIRELESS SURVEILLANCE SYSTEM

WITH INDOOR/OUTDOOR NIGHT VISION CAMERA

LW2100 Series - quick start guide

C. Receiver Function Buttons

About Digital Wireless

Did you know?

Press the Left, Right, Up, Down buttons to navigate in Menu Mode. Use these buttons to Pan/Tilt the image in ZOOM Mode (QVGA Mode Only).

Press the M to enter or exit Menu Mode.

Press the ZOOM Button to Zoom In (QVGA) or Zoom Out (VGA).

Press the CAM Button to switch to a different Camera on the Receiver

	Digital Wireless		Analog Wireless
	2.4 GHz Digital		2.4 GHz Analog
	Secure privacy ensured		Non Secure, no privacy
	Interference FREE		Interference from
	WiFi	Bluetooth
			WiFi	Bluetooth
			ANALOG WIRELESS
	DIGITAL WIRELESS

You can move your camera around from one room to another with the use of the included battery adaptor.

1 2

Cordless Phone		Microwave	Microwave	Cordless Phone
 Range up to 450 ft line of sight			Up to 300 ft line of sight
 Pairing - hand shake between camera and receiver			No Pairing - fixed channel allocation
	FHSS - Frequency Hopping Spread Spectrum Technology		N/A
	Supports 2 resolutions		Supports only one resolution

1. Connect camera to the Battery Adaptor.

NOTE: Decide whether the camera will be permanently wall mounted or placed on a tabletop:

•If you decide to place the camera on a tabletop or other flat surface (ensure to secure the camera with proper screws, thereby preventing it from falling down and damaging the lens and surface) the camera can easily be moved to different locations as desired. (Using this option will allow you to use the Battery adaptor, which provides flexibility by moving the camera from room to room).

•If you decide to permanently mount the camera to a wall, make sure to select a location close to a power outlet.

2. Slide open the Battery Adaptor Case to add batteries (not included).

3

3.Insert 4 x AA Batteries into the Battery Pack. Make sure to correctly line up the Positive (+) and Negative (-) terminals of the batteries.

4.Slide the Battery Pack cover back on.

5.NOTE: It is recommended to remove the battery pack from the camera when not in use.

	VGA: 640 x 480
	QVGA: 320 x 240
	Digital PTZ (Pan/Tilt/Zoom)	N/A
	Signal strength Indicator	N/A

The table above shows that Digital Wireless Technology offers many advantages over Analog wireless. When comparing a Digital Wireless solution to a wired solution, it is important to be aware of the bandwidth limitations. Due to bandwidth constraints and depending on the signal strength the frame rate, which is measured in FPS (Frames per Second) may be reduced. For example, a Digital Wireless camera in the highest resolution (VGA 640x480) will feature a lower frame rate compared to a wired solution which provides 30 FPS. It is possible to achieve 30 FPS with Digital Wireless by using the lower resolution (QVGA 320x240). For specific Frame Rate details, please refer to the Viewing Modes section in the User Manual.

It’s all on the Web

For detailed setup information, please refer to your User’s Manual. For additional information, please visit our website www.lorexcctv.com/support

www.lorexcctv.com	©2008 Lorex Technology Inc.
	As our product is subject to continuous improvement, Lorex Technology & subsidiaries reserve the right to modify product design, specifications & prices
	without notice and without incurring any obligation. E&OE

LW2100 SERIES Series Quick Start Guide_R1 Page

LW2100 Series_QSG_EN_R1.indd 2

5/6/2008 5:05:35 PM