LOREX Technology SC21CD5444UQ-A80 manual Off

(vi)HDD SLAVE: Select [Y] to enable the system to check for a Slave HDD upon startup. Enabling HDD SLAVE allows you to record to and playback from the Slave HDD (The HDD you connect to the IDE-SUB on the back of the monitor). For more information regarding how the Slave HDD backs up the Master HDD, please refer to page14.

Note: After activating the Slave HDD, you need to restart your system by turning the Main Power Switch (located on the back of the monitor) OFF and then ON again in order for the system to recognize the Slave HDD.

9.ALARM REC SET - This submenu allows you to configure the Recording parameters under the Alarm condition.

(i)ALARM REC : This setting selects whether or not the DVR will record automatically when a Motion Detection or a PIR alarm is triggered.

(ii)REC QUALITY : Selects the Recording Quality level for Alarm Recording (from Normal, High, or Best).

(iii)REC SPEED : Sets the speed of Alarm Recording from 60 / 30 / 15 / 08 / 04 / 02 / 01 IPS.

(iv)REC DURATION : Selects how long the DVR will automatically record after an alarm is triggered. Available duration times are: [ 20SEC / 30SEC / 1MIN / 2MIN / 5MIN and CONTIN] CONTIN refers to Continuous recording.

10.SCHEDULE REC SET - This Submenu allows you to Schedule times in which you’re programming the DVR to record automatically.

(i)SCHEDULE REC : Select from the following types of Scheduled recordings:

[DAILY] - Recording will be carried out according

		to a specified time on a daily schedule. The
		Date will be disregarded.
[OFF]	-	No schedule.
[ONCE]	-	Recording will be carried out one time,
		according to the schedule.

(ii)N0-N7- Select the Starting Time and Date for up to 7 scheduled recordings, plus the End Time.

[S CHE DULE REC SE T ]

SCHEDULE RE C : [ OFF ]

N0 : _ _ / _ _ _ _ : _ _ -> _ _ / _ _ _ _ : _ _

N1 : _ _ / _ _ _ _ : _ _ -> _ _ / _ _ _ _ : _ _

N2 : _ _ / _ _ _ _ : _ _ -> _ _ / _ _ _ _ : _ _

N3 : _ _ / _ _ _ _ : _ _ -> _ _ / _ _ _ _ : _ _

N4 : _ _ / _ _ _ _ : _ _ -> _ _ / _ _ _ _ : _ _

N5 : _ _ / _ _ _ _ : _ _ -> _ _ / _ _ _ _ : _ _

N6 : _ _ / _ _ _ _ : _ _ -> _ _ / _ _ _ _ : _ _

N7 : _ _ / _ _ _ _ : _ _ -> _ _ / _ _ _ _ : _ _

RETURN	: { J ]
EX IT	: { J ]

Note : When SCHEDULE REC is set up, the recording time should not be overlapped from one scheduled recording to another. If it is overlapping this will result in a loss in recorded activity and the schedule may be ignored.

To delete a scheduled recording, place the cursor on the selected time and press the key. "CURRENT LINE DELETE? [Y] / [N]” is then displayed. If [Y] is selected, the selected schedule is deleted.

-12-