LOREX Technology SC325000 instruction manual Sensor Set, Motion Set

Sensor Set

Sensor Set

This submenu allows you to change the settings for a separate sensor device (such as a stand-alone Motion Sensor, or Door/Window Sensor). These sensors are installed on the ALARM

BLOCK (see page 41 for Alarm Block Configuration).

1. SENSOR RECORD DURATION - Sets the length of time for the recording once a sensor input has been detected (i.e. If Motion is detected, the DVR will start recording, and will continue recording for 10 seconds). Navigate to this option using the buttons, and press the button to change the option to one of the following settings: OFF / 10 / 20 / 30 / 40 / 50 and 60 seconds.

2. SENSOR1 - SENSOR4 - Sets the input type for each sensor. Navigate to this option using the buttons, and press the button to change the option to one of the following settings: N/OPEN (Normally Open) or N/CLOSE (Normally Closed).

SENSOR

SENSOR RECORD DUR.[ 10 SEC]

SENSOR1		[ N/OPEN ]
SENSOR2		[ N/OPEN ]
SENSOR3		[ N/OPEN ]
SENSOR4		[ N/OPEN ]
[	]MOVE [	]SELECT [ˆ]EXIT

Motion Set

This submenu allows you to change the settings for cameras with integrated motion sensors.

1. MOTION RECORD DURATION - Sets the length of time for the recording once motion detection has been detected. Navigate to this option using the buttons, and press the button to change the option to one of the following settings: OFF /

10 / 20 / 30 / 40 / 50 and 60 seconds.

2. CHANNEL1 - CHANNEL4 - Sets the Channel to ON/OFF for recording Motion. Navigate to this

option using the buttons, and press the button to change the option.

3. SENSITIVITY - Sets the sensitivity for Motion Detection from 1 (low sensitivity) to 5 (high sensitivity). Navigate to this option using the buttons, and press the button to change the option.

MOTION

MOTION RECORD DUR. [ 10 SEC]

CHANNEL1		[ N]
CHANNEL2		[ Y ]
CHANNEL3		[ N ]
CHANNEL4		[ N ]
SENSITIVITY		[ 3 ]
[	]MOVE [	]SELECT [ˆ]EXIT

21