Connecting Alarm Device - Appendix #5

Connecting Alarm Device - Appendix #5

Alarm controls are enabled through the Menu system on the DVR. Additional alarm devices can be connected to the system (Motion Sensors, Door/Window Sensors).

DVR

SENSOR

A motion detection or sensor unit can be used to send a signal to the DVR to begin camera viewing on the matching Video Channel (when enabled in the MENU/ALARM SET MODE)

Example: A Window sensor unit has been installed on Alarm Block port #1. When this sensor is activated, ALL CAMERAS will become active (if enabled in the MENU on the DVR)

For the corresponding Menu Programming, refer to Page 26.

Installing a Sensor

1.Connect the GROUND Cable to the GND port on the Alarm Block on the DVR

2. Connect the SIGNAL Cable to a numbered port (1-4)

2 1

41

Page 41
Image 41
LOREX Technology SC325000 instruction manual Connecting Alarm Device Appendix #5, DVR Sensor