Installation Template, Items | LOREX Technology WA-410 specification

Items

Frequency

Power Source

Power Consumption

Back-up Battery (Optional)

Temperature Range

RF Range

Security Code

Alarm Activation Time

Dialing Type

Voice Message Playing Time

Preset Telephone Numbers

Material

Weight

Dimensions

Specifications

- 303Mhz or 433Mhz

- AC120V, DC 12V

- 70mA (idle), 170mA (activated)

- Approximate 7 hours ( NO AC adaptor)

- 0°C 40°C

- 100 feet in open air space

- Hopping code

- 1~255 seconds (available alarm time setting)

- Tone

-Total 25 seconds

- 6 phone numbers, 20 digits for each number

- ABS

- 650 g

- 26 cm X 17 cm X 3.5 cm

Installation Template

26

Image 27

LOREX Technology WA-410 instruction manual Installation Template, Items, Specifications

Contents

Wireless Home Security System Table of Contents Important Safety Instructions Introduction ExpandabilityPersonalized Choosing Location Planning for InstallationSetting Alarm Zones Powering the Main Console Mounting the Main Console Connecting the Telephone LineSetting the Antenna About Passwords LCD Panel Illustration Operation Main Console Line Jack Antenna Used for wireless receptionDC Power Jack DC supply input Speaker System Option menu Press 0 to start setting Setting Change Code Install Setting Message Rec Sel Msg 1 25 SecSetting Message Play Sel Msg 1 25 Sec Setting Dialer Mode Sequence Programming Menu Clear Menu Replacement Menu Function for Master Menu Factory Default Password Speed Dial Function Check Function If system is triggered Arm or Disarm Via the Telephone Line for Tone ModeAuto-dialer priority Response message as listed below Away and H-HOME modes Hour ModeGas Detector and Remote Control Handset Panic button LCD MSG Message indicating on LCD Remote Sensor Armed Home Remote Control HandsetZone Address Setting To Arm or Disarm with the Remote Control Handset Main Features PIR Motion DetectorPanic Do not install any PIR motion sensor in the following areas Replace the BatteryInstalling the PIR Motion Sensor Low battery Door/Window Detector To install the PIR Motion Sensor, please follow these steps Door/Window Detector for DC 12V battery Change the Battery Tamper Installing the Door/Window DetectorInstalling for DC 12V Detector LCD display on the Main Console for Door/Window Detector Mini Siren Summary of Program Main Console Descriptions Summary of Sensors and Zone Settings Learning Place Zone Label Specifications Installation Template SpecificationsItems Page It’s all on the web