Louisville Tin and Stove CF504R, CF654C-R Auxiliary Limit Switch, Maintenance Instructions

TERMINAL BLOCK WIRING DIAGRAM

	FAN/LIMIT SWITCH (Brown)			FAN/LIMIT SWITCH (Brown)
		SELECTOR
	POWER CORD (Black)			POWER CORD (Black)
		SWITCH
	TRANSFORMER
		(Red)		TRANSFORMER(Black)
	(Black)
	LIMIT				LIMIT
	SWITCH	MOTOR
					SWITCH
	(Blue)	(Red)	MOTOR (White)		(Blue)
MOTOR (White)
POWER	FAN	POWER			SELECTOR
CORD	SWITCH	CORD			SWITCH
(Green)	(Black)	(Green)			(Black)
TERMINAL BOARD	MOTOR (Black)	TERMINAL BOARD		MOTOR (Black)
GROUND (Green)	TRANSFORMER (Black)	GROUND (Green)		TRANSFORMER (Black)
MOTOR (Green)		MOTOR (Green)
P/N 91122	POWER CORD (White)	P/N 91123		POWER CORD (White)
CF353C, CF354C, CF357C, CF358C		CF503C, CF504C, CF557C, CF558C, CF653C, CF654C

CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

AUXILIARY LIMIT SWITCH

For your safety this furnace is equipped with a manual reset auxiliary limit switch. In case of failure by the primary limit switch, this switch will shut the valve down completely before unsafe temperatures are reached. After a cool down period, switch must be manually reset. If outages persist, call a qualified service person.

MAINTENANCE INSTRUCTIONS

1.Installation and repair must be done by a qualified service person. The appliance should be inspected before use and at least annually by a professional service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. It is imperative that control compartments, burners, pilot burners, circulating air passageways and venting systems of the appliance be kept clean.

2.The bearings of the motor should be oiled every six months with S.A.E. 20 oil.

3.The appliance area must be kept clear and free of any combustible materials, gasoline and other flammable vapors and liquids.

4.It is essential that the flow of combustion and ventilation air not be obstructed.

5.Periodic examination of the entire ventilation system as a routine part of the safety performance check is recommended on an annual basis.

IMPORTANT: Keep burner and control compartment clean. Vacuum burner compartment at the start of the heating season or as often as needed.

NOTE: It is advised that the burner flames be checked at least twice during the heating season for any changes in burner flame characteristics.

115 VAC 60 HZ – Less than 12 Amps. If any of the original wire as supplied with this appliance must be replaced, it must be replaced with type thermoplastic 105-degree C wire or its equivalent.

Page 13